Qualstar XLS Series, Technical & Service Manual

Page: 139 / 366

9
Installing or Replacing Cartridge Slots and Drive Bays
XLS Library Technical Service Manual 9-
125
4. Using a magnetized #2 Phillips screwdriver, loosen and remove the two screws
that hold the cartridge magazine in place. See Figure 9-2 .
Figure 9-2 Location of screws for cartridge magazine
Important: Be sure to replace the magazine before powering the
library back on. If the library detects that a magazine is
missing during the fiducial scan, the operation will fail.
9.2.2 Installing a Cartridge Magazine
To install a cartridge magazine, follow these steps:
1. Locate the cartridge magazine mounting holes on the frame.
2. Insert two 6-32
×
3/8 Phillips screws through the two holes in the cartridge
magazine and into the frame. See Figure 9-2 .
3. Using a Phillips screwdriver, tighten the screws.
4. Replace any cartridges you removed.
5. If the cartridge magazine is located on a fixed port assembly, replace the front
panel. See Section 10.2 on page 10-7 . If the cartridge magazine is located in an
XLS-812300 expansion pod, swing the pod closed, then replace the three
socket-head cap screws.