53
Signal Tower LA6-POE Operation Manual
5.5.2. Smart Mode
There are three kind of modes, "Time-trigger Type", "Pulse Trigger Type", and "Single-display Type". The main mode has
common functions for each type and has the following at this mode.
<Input 6 (Mute input)>
The buzzer sound stops when an "ON" input occurs, and muffles the sound.
<Input 7 (clear input)>
If an input for each type is set to ON, the pattern contents which are controlling the operation will be initialized and it will
return to the first pattern. Also, LED's from all the tiers will go out at an "ON" input, and the buzzer is also muffled.
For the LED unit setup, (Refer to “4.4 LED Unit Setup” on page 20)
MEMO
The "Flashing/Pulse Enable Common" cannot be used in the smart mode.
5.5.2.1. Time-trigger Type
The pattern transitions can be controlled in accordance to time. Execute up to a maximum of 15 groups, with inputs 1-4.
<Input-group compatibility table>
For inputs 1-4, group No. in the combination of ON/OFF can be put into the diagram.
Group No.
Input 1
Input 2
Input 3
Input 4
1
ON
2
ON
3
ON
ON
4
ON
5
ON
ON
6
ON
ON
7
ON
ON
ON
8
ON
9
ON
ON
10
ON
ON
11
ON
ON
ON
12
ON
ON
13
ON
ON
ON
14
ON
ON
ON
15
ON
ON
ON
ON
An empty cell indicates the "OFF" condition.
* The following control can be done with the time trigger type.
• Turn on input 5
Use STOP to halt the progress of pattern changes.
• Turn on input 6
Mute the buzzer.
• Turn on input 7
The operation and time progress is controlled with a "Clear" (reset)
