10
Signal Tower LA6-POE Operation Manual
3.1.2. Stationary Type
❶
Loosen the screw to remove the bottom
plate. (Do not completely remove the screw.)
❷
The lock on the terminal block connector
can be unlocked and removed for wiring.
(Refer to 3.1.3. Terminal block
Method)) (Refer to 3.2. Wiring)
❸
The LAN unit is connected to the terminal
block connector and LAN cable.
Recommended Torque
0.6N/m (Standard)
❹
The tab on the bottom of the stand cover is
hooked in place and secured with a screw.
❺
Apply the rubber sheet onto the bottom
plate. The rubber sheet is peeled from the
yellow releasing paper, and is to be stuck
onto the bottom plate.
The transparent protection sheet on
the rubber sheet is to be removed after
attachment.
Stand Cover
Bottom
Plate
Screw
Tab
Tab
Rubber
Sheet
Terminal Block Connector
Wiring
Through-hole
LAN Cable
LAN Unit
4
4
1
3
2
5
Mounting Dimensional Drawing
■
(Unit:mm)
Mounting Hole
(φ5x3 places)
Product Front
(Buzzer Diaphram)
φ
116
120°
120°
Nameplate
Location
LAN Unit Outer
Dimensions
※
The figure shows the most common installation
circumstances, but cannot show for every possible
circumstance.