16
Signal Tower LA6-POE Operation Manual
4.1.3. When Mirroring
①
Set up the LA6-POE network.
• Set the IP address for the network. (Refer to “4.3 Network Setup” on page 19)
②
Set up the LED unit colors and combinations.
• Use the data setup application to create the LED unit colors and combinations.
(Refer to the help section in the data setup application.)
• Use the Web Setup Screen to set up. (Refer to "4.4.2 WEB Setup" on page 22)
③
Load the Setup Data information into the LA6-POE.
• Use the data setup application to load the data. (Refer to "4.4.1 Loading Setup Data" on page 20R)
* Be sure to write the same information for the mirroring point and mirroring origin.
④
Mirroring Setup
• Setup mirroring for the point of origin, establishing the "Master."
(Refer to "4.9.1 Setting up the Mirroring Source" on page 29)
• Setup mirroring for the target point, establishing the "Slave."
(Refer to "4.9.2 Setup Mirroring Destination Point" on page 30)
4.1.4. When Collecting the Signal Tower Information
[ Retrieving the Signal tower information submitted by a LA6-POE ]
①
Set up the LA6-POE network.
• Set the IP address for the network. (Refer to “4.3 Network Setup” on page 19)
②
Set up the LED unit colors and combinations.
• Use the data setup application to create the LED unit colors and combinations.
(Refer to the help section in the data setup application.)
• Use the Web Setup Screen to set up. (Refer to "4.4.2 WEB Setup" on page 22)
③
Load the Setup Data information into the LA6-POE.
• Use the Web Setup Screen to load the data. (Refer to "4.4.1 Loading Setup Data" on page 20R)
* When writing data using the USB cable,be sure to synchronize the data in the "Main unit setup" screen.
④
Set up the control method.
• In the "Main Unit Setup" screen, set to the ”Signal Wire control.” (Refer to "4.5 Main Unit Setup" on
⑤
Set up the Signal Tower Information Transmission.
• Set the receiver address. (Refer to "4.10 Information Transmission Setup" on page 31)
•
Configure the Signal Tower Input Judgment.
(Refer to "4.10 Information Transmission Setup" on page 31)
• Select the smart mode information to send. (Refer to "4.10 Information Transmission Setup" on page 31)
