Panasonic VF200, Instruction Manual

Page: 150 / 289

Appendix Function Parameter List
14
3
■
3-wire run/stop command
Please assign “3-wire stop command” to any input terminal of SW1 to SW5.
The following connection example indicates the situation that “3-wire stop
command” is assigned to input terminal SW1.
Setting
value
Command
status
Panel reset
function
Operation method and control circuit terminal
connection diagram
2
External
control
×
4
External
control
○
Common terminal
(Ternimal No. 1 or No. 8)
ON: Start
ON: Reverse run/OFF:
Forward run
ON: Stop (*1)
3
External
control
×
5
External
control
○
Common terminal
(Ternimal No. 1 or No. 8)
ON: Forward run
ON: Reverse run
ON: Stop (*1)
(*1) If any terminal of SW1 to SW5 (control circuit terminal No. 4 to No. 8) is
used as “3-wire stop command”, please set “P036 to P040: SW1 to SW5
Function Select” to “10” (3-wire stop command). In addition, please note
that even if “P041: Input Logic Setting” is set to “a contact input”, “b
contact input” will still apply.
■
Panel reset function
When a fault trip occurs, reset cannot be made with stop signal input from
external devices. Therefore, use STOP SW on the panel to reset the fault trip.
But if the reset lock function is used, it will take precedence. In addition, reset
fuction is also valid.
・
If forward run and reverse run signal are turned ON simultaneously, the
operation status will not be changed. If the inverter is stopped and both
signals are turned ON simultaneously, the operation will not start.
Related parameters: P036 to P040