23 On-the-fly marking
23.3 On-the-fly-marking settings for one file
The detailed parameters for on-the-fly marking apply to the selected marking file only.
“Workpiece spacing [mm]”
Set this parameter if “Marking at regular intervals” is set for “Trigger mode”.
For “Workpiece spacing [mm]”, specify the distance to the next marking data object (to the
next workpiece).
ABC
ABC
ABC
ABC
(2)
(1)
(1) “Workpiece spacing [mm]”: Distance between workpieces
(2) Workpiece
“Line speed [m/min]”
“Line speed [m/min]”: Specify this setting if “Fixed speed” is set for “Line speed control”.
“Line speed for test marking [m/min]”: Specify the reference line speed used for test marking
if “Encoder input” or “2 sensors input” is set for “Line speed control”.
Remarks
• If “Encoder input” or “2 sensors input” is set for “Line speed control”, the current line
speed is calculated based on the input signals from the encoder or the sensor. You can
check the line speed in “Monitor” > “On-the-fly”.
• Adjust the setting value of the line speed by checking the marking quality.
‒ When the character spacing is too wide, increase the value.
‒ When the character spacing is too narrow, decrease the value.
“Workpiece reference boundary [mm]”
The workpiece reference boundary is used as a reference line to specify the position of the
marking data. The distance between the workpiece reference boundary and the marking
data defines the marking position on the workpiece.
Set the workpiece reference boundary at the same position as the detecting boundary of the
trigger sensor (trigger detecting position) and place the marking data.
Example
244
ME-NAVIS2-OP-1
