27 Troubleshooting
E625
Cause:
No response is returned from the imagechecker. Marking trigger
processing terminated abnormally. (Applies to the linking of image
processing devices.)
Remedy:
• Check the connecting status between the laser marking system and
the imagechecker.
• Check if the reading process of the imagechecker was successful.
• If you use PV230/PV200, set the total judgement.
E626
Cause:
The settings on the laser marking system and imagechecker do not
match. Marking trigger processing terminated abnormally. (Applies to the
linking of image processing devices.)
Remedy:
• Check the settings for application, type number, and checker number
on the laser marking system and imagechecker.
• Check the Ethernet settings for PV230/PV200 and for the laser
marking system. For PV230/PV200, “Protocol” is set to “General
Com.” (general communication) in the Ethernet setting table. The
general communication protocol is used for the communication with
the laser marking system.
E627
Cause:
Code or character checking failed because no bar code, 2D code
or character settings are available. (Applies to the linking of image
processing devices.)
Remedy:
• Check if the number set for “Object No. to check” in file settings is
the same as the object number you set in the bar code, 2D code or
character object settings.
• For code checking, make sure the code type and the settings of the
bar code or 2D code object match the code reader configuration.
• For character checking, check if the character type and number of
characters in the marking data are supported by the imagechecker.
338
ME-NAVIS2-OP-1
