OTARI RADAR II, Operation Manual, Page: 219 / 261

A.4.5.4 MIDI Time Code (MTC) Connections
MIDI Time Code (MTC) is a sync protocol used by samplers and MIDI control
equipment. The MIDI inputs and outputs use standard DIN-5 connectors. MIDI
IN is passed through to MIDI THRU; MIDI OUT outputs MTC, even if the
system is not set to sync to MIDI.
A.4.5.5 Video Sync Connections
If using Video Sync (house sync), connect the sync source to the Sync Reference In
BNC connector on RADAR’s rear panel.
The Sync Reference Out connector provides a hard-wired loop through; you may
connect this output to other device(s) requiring the same sync source.
Electrical Termination of Video Source
If the video source requires ground termination, a 75
Ω
termination resistor may be
inserted using the switch between the Sync Reference connectors. Generally,
termination is required if RADAR is the last device (or only device) in the sync
chain, and if there is no downstream device connected to Sync Reference Out.
Do not insert the termination resistor if any device is connected to the Sync
Reference Out BNC!
A.4.5.6 Digital Word Clock Connections
If using RADAR with an external digital word clock source, connect this source to
the Sync Reference In connector. If a loop-through is required, you may connect
the Sync Reference Out BNC to the device requiring the same digital word clock.
Please refer to the above note regarding termination for digital Word Clock; insert
the termination resistor if necessary to maintain proper signal conditions.
Edition 1
A-12 A P P E N D I X A