OPTICAL SYSTEMS DESIGN
DOC ID: 10118101
OSD2512 OPERATOR MANUAL
PAGE 104
Access Control List Configuration
Configuration
Security
Network
ACL
Access Control List
This page shows the Access Control List (ACL), which is made up of the ACEs
defined on this switch. Each row describes the ACE that is defined. The maximum
number of ACEs is
256
on each switch.
Click on the lowest plus sign to add a new ACE to the list. The reserved ACEs used
for internal protocol, cannot be edited or deleted, the order sequence cannot be
changed and the priority is highest.
ACE
Indicates the ACE ID.
Ingress Port
Indicates the ingress port of the ACE. Possible values are:
All
: The ACE will match all ingress port.
Port
: The ACE will match a specific ingress port.
Policy / Bitmask
Indicates the policy number and bitmask of the ACE.
Frame Type
Indicates the frame type of the ACE. Possible values are:
Any
: The ACE will match any frame type.
EType
: The ACE will match Ethernet Type frames. Note that an Ethernet Type based ACE
will not get matched by IP and ARP frames.
ARP
: The ACE will match ARP/RARP frames.
IPv4
: The ACE will match all IPv4 frames.
IPv4/ICMP
: The ACE will match IPv4 frames with ICMP protocol.
IPv4/UDP
: The ACE will match IPv4 frames with UDP protocol.
IPv4/TCP
: The ACE will match IPv4 frames with TCP protocol.
IPv4/Other
: The ACE will match IPv4 frames, which are not ICMP/UDP/TCP.
IPv6
: The ACE will match all IPv6 standard frames.
Action
Indicates the forwarding action of the ACE.
Permit
: Frames matching the ACE may be forwarded and learned.
Deny
: Frames matching the ACE are dropped.
Filter
: Frames matching the ACE are filtered.
