OPTICAL SYSTEMS DESIGN
DOC ID: 10118101
OSD2512 OPERATOR MANUAL
PAGE 279
DETAILED LINK OAM STATUS FOR PORTS
Monitor
Link OAM
Port Status
This page provides Link OAM configuration operational status.
The displayed fields shows the active configuration status for the selected port.
LOCAL AND PEER
Mode
The Mode in which the Link OAM is operating, Active or Passive.
Unidirectional Operation Support
This feature is not available to be configured by the user. The status of this configuration is
retrieved from the PHY.
Remote Loopback Support
If status is enabled, DTE is capable of OAM remote loopback mode.
Link Monitoring Support
If status is enabled, DTE supports interpreting Link Events.
MIB Retrieval Support
If status ie enabled DTE supports sending Variable Response OAMPDUs.
MTU Size
It represents the largest OAMPDU, in octets, supported by the DTE. This value is compared to
the remotes Maximum PDU Size and the smaller of the two is used.
Multiplexer State
When in forwarding state, the Device is forwarding non-OAMPDUs to the lower sublayer. In
case of discarding, the device discards all the non-OAMPDU's.
Parser State
When in forwarding state, Device is forwarding non-OAMPDUs to higher sublayer. When in
loopback, Device is looping back non-OAMPDUs to the lower sublayer. When in discarding
state, Device is discarding non-OAMPDUs.
Organizational Unique Identification
24-bit Organizationally Unique Identifier of the vendor.
