OPTICAL SYSTEMS DESIGN
DOC ID: 10118101
OSD2512 OPERATOR MANUAL
PAGE 158
PRI
Priority of Interface.
It indicates the MLD control frame priority level generated by the system. These values can be
used to prioritize different classes of traffic.
The allowed range is
0
(best effort) to
7
(highest), default interface priority value is 0.
RV
Robustness Variable.
The Robustness Variable allows tuning for the expected packet loss on a link.
The allowed range is
1
to
255
, default robustness variable value is 2.
QI
Query Interval.
The Query Interval is the interval between General Queries sent by the Querier.
The allowed range is
1
to
31744
seconds, default query interval is 125 seconds.
QRI
Query Response Interval.
The Maximum Response Delay used to calculate the Maximum Response Code inserted into
the periodic General Queries.
The allowed range is
0
to
31744
in tenths of seconds, default query response interval is 100
in tenths of seconds (10 seconds).
Last Listener Query Interval.
The Last Listener Query Interval is the Maximum Response Delay used to calculate the
Maximum Response Code inserted into Multicast Address Specific Queries sent in response to
Version 1 Multicast Listener Done messages. It is also the Maximum Response Delay used to
calculate the Maximum Response Code inserted into Multicast Address and Source Specific
Query messages.
The allowed range is
0
to
31744
in tenths of seconds, default last listener query interval is 10
in tenths of seconds (1 second).
URI
Unsolicited Report Interval.
The Unsolicited Report Interval is the time between repetitions of a node's initial report of
interest in a multicast address.
The allowed range is
0
to
31744
seconds, default unsolicited report interval is 1 second.
Buttons
: Click to add new MLD VLAN. Specify the VID and configure
the new entry. Click "Save". The specific MLD VLAN starts working after the
corresponding static VLAN is also created.
: Click to save changes.
: Click to undo any changes made locally and revert to previously saved
values.
