![background image](http://html1.mh-extra.com/html/omron/ej1-ethercat/ej1-ethercat_user-manual_742375144.webp)
119
Programless Communications
Section 5-1
2.
Make the PLC settings.
Use the CX-Programmer to make the communications port settings for the
Serial Communications Unit. The settings can be easily made using IO Ta-
ble and Unit Setup. Be sure to transfer the settings to the PLC.
Note
(1) m = 100
×
Unit No. (word address)
(2) When using a communications port on the CPU Unit, start the CX-Pro-
grammer and set the Host Link port settings in the PLC Settings as fol-
lows: Mode: NT Link (1: N), Baud rate: 115,200. Be sure to transfer the
settings to the PLC.
(3) The same serial port on the CS/CJ-series Serial Communications Board/
Unit cannot be connected to both the EJ1 and an NS-series Programma-
ble Terminal.
The following settings are also required if the models listed below are used.
Note
The port 2 terminating resistance switch and 2/4-wire switch are on the bot-
tom of the Unit.
3.
Set the EJ1 parameters.
No particular EJ1 parameter settings are required when using SYSMAC
CS/CJ-series PLCs. Leave the parameters set to their default settings.
When using RS-232C communications, turn ON pin 8 of SW2 to select RS-
232C communications.
For the default settings, the EJ1 monitor and set values are allocated in the
DM Area in the PLC as shown in the following table.
DM Area
Bits
Settings
Set
value
Board CS Series only
Unit CS/CJ Series
Port 1
Port 2
Port 1
Port 2
D32000
D32010
m
m+10
15
Port settings
Setting not required. 0200H
14 to 12 Reserved
---
11 to 08 Serial communications mode NT Link (1: N)
07 to 05 Reserved
---
04
Start bits
Setting not required.
03
Data length
Setting not required.
02
Stop bits
Setting not required.
01
Parity
Setting not required.
00
Parity
Setting not required.
D32001
D32011
m+1
m+11
15 to 04 Reserved
---
000AH
03 to 00 Baud rate
High-speed NT Link
D32006
D32016
m+6
m+16
15 to 03 Reserved
---
0000H
02 to 00 Maximum unit number
0
Model
Terminating resistance ON/OFF switch 2-wire/4-wire switch
CJ1W-SCU41-V1
CJ1W-SCU31-V1
(See note.)
CS1W-SCU31-V1
CS1W-SCB41-V1
ON
2
Summary of Contents for EJ1 EtherCAT
