NORDAC FLEX (SK 200E ... SK 235E) – Users Manual for Frequency Inverters
46
BU 0200 en-US-4920
1
Adapter plate
Figure 10: SK 2xxE with wall mounting kit
Figure 11: SK TIE4-WMK… (…1-EX / 2-EX)
Pos : 88 /Anl eitungen/ Elek tronik/FU und Start er/ 2. M ont age und Ins tall ati on/M ont age/W andm ontage - Ergänz ung [SK 1xx E, SK 2xxE]/Wandmont ageki t mit Lüft er [ 2xx E] @ 22\mod_1529335270650_14638. doc x @ 2427436 @ 4 @ 1
2.1.3.2
Wall mounting kit with fan
Pos : 89 /Anl eitungen/ Elek tronik/FU und Start er/ 2. M ont age und Ins tall ati on/M ont age/W andm ontage - Ergänz ung [SK 1xx E, SK 2xxE]/Wandmont ageki t SK T IE4 WM K L … [SK 2xx E] @ 58\mod_1605705686553_14638. doc x @ 2693120 @ 5 @ 1
Wall mounting kit SK TIE4-WMK-L-…
The wall mounting kit SK TIE4-WMK-L-… enables the variable frequency drive to be installed close to
the motor. With this kit, the variable frequency drive can comply with the IP55 or IP66 rating
depending on the version.
• This kit is only available for inverter sizes 1 to 3.
• This kit cannot be combined with the device variants SK 22xE and SK 23xE (devices with AS
interface).
When installing make sure that the fan is located below the cooling fins of the inverter. The fan
connection cable must be inserted through the cable inlet in the variable frequency drive connection
unit (see diagram below) and wired to +24 V DC (red cable) and GND (black cable) on the terminal
block.
Power consumption of fan:
approx. 1.3 W
Information
Derating
Use of the wall mounting kit SK TIE4-WMK-L-1 (or -2) allows the variable frequency drive to have
continuous ventilation. Therefore the permissible continuous outputs of a 3-phase variable frequency
drive correspond to those of a motor-mounted inverter. For single-phase variable frequency drives the
same power data applies to wall mounting. Please refer to the technical data (please see chapter 7.2
"Electrical data" on page 237)for details.