This selection allows the source to the 2T mixer to be
Pre-
or
Post-
the
8T faders.
Tone to 2T
Indication that tone be selected to 2T or not, is dependent on the
selection in the
Settings
screen.
2T Output / 2T Level
Allows you to globally turn all of the 2T Outputs On/Off, and set the 2T
mixer output level from
0dB to ∞
NB:
In Pre-mode, the 8T Inserts should be selected to be Pre- to
pickup the pre-processing pre-fade 8T signal. If this is the
required source to feed to the 2T mixer.
On exiting Master SEL Mode, the 2T and SEL buttons will cease
flashing and the screen will revert to showing it's previous display
(but will not reinstate 2T Mix screen if selected).
It should also be noted that the previously described monitoring
setups using LOCK/RTE SEL, can be set using the Settings Screen
as well, apart from setting up the 2T mixer which must be done via
LOCK/RTE SEL method.
TALKBACK Section
Most of the Talkback functions can be accessed remotely via relays and
the 5V-CTL from the back of the console on a 15-pin D-type connector.
These relays & the 5V-CTL also allow the remote operation of the
Loudspeaker
CUTS
,
DIM, TALKBACK
to
CUE 1
/
CUE 2
,
RED LIGHT
,
RTB ON
and
SLATE
.
CUE 1
&
CUE 2
Each of these level controls and momentary switches can be used to set
the talkback level to each Cue.
It has a range of -∞ to 0dB.
u
Press to enable, the adjacent LED will light and send Talkback to the
Cue. It will also turn on the
DIM
button, and the display will temporarily
display the amount of dim, set by the
DIM TB
preset. This is located
above the Monitor
DIM
button. It will also dim the CUE mixer level so that
Talkback can clearly be heard over the Cue Mix.
If
RTB
is on
M2 SEL
, then the action of talking to CUE 1 or CUE 2 will
temporarily suspend
RTB,
whether it is selected locally or externally.
As stated, it is possible to talk to the Cues externally, in which case each
Cue light will flash, along with
DIM
, to show remote control.
NB:
Selecting Auto TB in the settings screen will make CUE 1 and 2
latching until Play from the Transport controls is selected, at
which point CUE TB is cancelled. Once Play is stopped, CUE 1 and 2
will be reinstated, allowing CUE TB to continue.
- 81 -
