CUE MIX Section
Each of the Cue mixes can be sourced from:
•
A stereo External
•
Either the Main Mix
or
the current Control Room Monitor selection
(set by
UTIL
knob)
•
Four mono Auxes or two stereo Aux.
EXT 1-4
This level pot and switch controls the currently selected External level into
the Cue.
If you have either of the Surround Externals selected, it will only send the
Left and Right to the Cue.
It has a range of –∞ to 0db.
u
Press to enable.
UTIL
This level pot and switch controls the Main Mix or the current Control
Room Monitoring level into the Cue, the selection being indicated by the
adjacent leds.
It has a range of –∞ to 0dB.
u
Press to enable.
NB. The selection of main mix or CRM is set in Master SEL mode.
AUX 1-6
This level control and switch controls the Aux contribution to the Cue mix.
u
Press to enable.
•
When
Aux 1 / 2
is selected, this will feed 1 to L & 2 to R.
•
When
Aux 3 / 4
is selected, this will feed 3 to L & 4 to R.
•
When
Aux 5
is selected, this will feed to L & R.
•
When
Aux 6
is selected, this will feed to L & R.
•
When
AUX 1 /2 and 3 / 4
are selected this will feed 1 and 3 to L and 2
and 4 to R.
•
When
AUX 5 and 6
are selected, this will feed 5 to L & R and 6 to L & R.
•
When
AUX 1 / 2 and 5
are selected, this will feed this will feed 1 to L
and 2 to R and 5 to L & R.
•
When
AUX 1 / 2 and 6
are selected, this will feed this will feed 1 to L
and 2 to R and 6 to L & R.
NB. The selection of Auxes is set in Master SEL mode.
TILT EQ
Has no On/Off switch associated, but the rotary control has a centre
detent to indicate a flat response.
It is used to brighten or dull the Cue mix being fed to the headphones, by
boosting either the higher or lower frequencies.
The
TILT EQ
control is stereo and has a range of +/-4dB @ 1.2 kHz.
BAL
This balances the Left and the Right of the Cue, and is in circuit all of the
time.
It has a range of +/-6dB.
- 70 -
It is possible to use a
single Cue in stereo, or
as two mono by hard-
panning the stereo
sources sent to it.
