screen, or via Master SEL Mode on the panel.
L / C / R / LS / S / RS
Will light red when individually selected and cut the appropriate speaker.
All of these buttons will light if Master
CUT
is selected.
If individual cuts are in place when the Master CUT is selected, these
individual cuts will be reinstated when the Master
CUT
is turned off.
Also, if some Cuts are selected or not selected when Master Cut is
selected then they will remain cut or not cut even when Master Cut is
deselected, allowing cuts groups to be formed.
Master CUT
Lights red and cuts all of the speakers.
All of the individual speaker buttons will also light red. It is also possible
to activate Master Cut remotely via the DC remote connector. This will
switch Master Cut ON and flash the Master Cut LED.
DIM
Lights yellow, and dims the speakers by a predetermined amount, set by
the Control Room Monitoring level knob (see below).
The
DIM
will also be forced onto the monitoring whenever the console
Talkback, Producers Talkback or Slate are in use or remote dim is applied.
The
DIM
LED will flash in remote
DIM.
MONO
Lights yellow and collapses a Stereo or Surround mix into mono.
Collapsing a 5.1 mix is done in conjunction with the
ST
button and the 5.1
MONO
tick box in the settings screen.
TB Trim
Whenever a Talkback is activated anywhere on console, this trim pot sets
the amount by which the monitoring will dim.
This is a global setting that applies the same dim value when any of the
Talkback to
CUE1
,
CUE2
,
TB
,
SLATE
or
TB ALL
buttons are pressed.
It has a range of 0dB to -40dB.
u
To set this value, press and hold down any of the
CUE1
,
CUE2
,
TB
or
SLATE
buttons on the Talkback panel. The value of the TB Trim will be
displayed relative to the Monitor Level or Master Dim level on the Monitor
Knob alpha display.
u
While holding the above button down, turn the trimpot above the
Master Dim button until the desired value is reached.
NB:
Factory set to -20dB
- 76 -
