Channels DLINE Input
This covers which audio is sent into the 8 Channels digital line (
DLN
)
inputs.
u
There are two options available, only one of which can be selected at a
time.
•
DLINE from DAW via FireWire: Takes the audio from your DAW through
the FireWire cable, and sends it to the digital Line input on the channel.
•
AES Receivers DLINE: Takes the audio from the AES digital DLINE
Receivers, and sends it to the digital Line input.
u
Once set, click
Apply
to reconfigure the FireWire buss with your
selection.
u
This input is selected on a channel-by-channel basis by pressing the
Input Selector Knob
at the top of a channel strip until the adjacent
DLN
LED lights blue.
This input will not be available for selection if an AD/DA card is not fitted
in that section of the console.
u
If you wish to swap ALL of the channel inputs to the Digital Line input,
then on the
CH SEL
section of Master Monitor Panel, make sure that none
of the
MIC
,
LN
or
DAW
buttons are selected.
Only once all these three options are switched off will the input will be set
to the digital line input.
The adjacent blue
DLN
LED will light to confirm this selection, plus the
DLN
LED will light on each channel strip that has an AD/DA card fitted.
Channels DMON Input
This selects the audio to be sent on the digital monitor path.
u
There are two options available, only one of which can be selected at a
time.
•
DMON from DAW via FireWire: Takes the audio from your DAW
through the FireWire cable, and sends it to the
DMON
Input of the
channel strip.
•
AES Receivers DMON: Takes the audio from the AES DMON Receivers
and sends it to the
DMON
Input of the channel strip.
u
Once set, click
Apply
to reconfigure the FireWire buss with your
selection.
u
This input is selected on the console surface by pressing the
IP2
button
near the bottom of the channel strip until the adjacent
DMON
LED lights
blue.
This input will only be available for selection if an AD/DA card is fitted in
that section of the console.
u
If you wish to swap ALL of the DAW inputs to the DMON inputs, then
on the
MON
SEL
section of Master Monitor Panel, make sure that none of
the
DAW SND
,
DAW
RTN
or
I/P2
buttons are selected.
Only once all these three options are switched off will the input will be set
to the digital monitor in.
The adjacent blue
DMON
LED will light to confirm this selection, plus the
DMON
LED will light on each channel strip that has an AD/DA card fitted.
- 155 -
