Channels Digital Converter System
(Part number
SMN 812–409
Master and Slave
)
This cassette provides 8 channels with AD/DA converters. Depending on
the digital channel requirements, a Master or Master and Slave card can
be installed in groups or individually.
Without this card, the
DLN
and
DMON
functionality (and leds) will not be
available on the console.
The digital converter board provides facility for Digital Line Inputs (DLN)
and digital DAW returns (DMON) into the desk plus enabling the Direct
Outputs on each channel to be sent digitally to the DAW.
Installation Instructions
•
Remove the mains power cord from the console
•
Remove the faceplate on the rear of the console (shown above) and
remove the connector blanking plate.
If a new faceplate has been
provided, discard the one removed and use the new one.
•
Slide the digital converter board upside down into the lowest slot and
push it to the rear until the connectors mate securely onto the
backplane.
•
Screw the faceplate back into place (at points highlighted in red
above), ensuring all the connectors comfortably clear the faceplate.
•
Secure all the connectors in place through the faceplate using the
included pillars and screws.
On larger consoles, it is possible to have one of each of the above cards for each block of 8 faders providing EQ,
Dynamics and digital lines/externals for the entire console.
For cards not initially present, the connector plates
on the console rear will be fitted with blank panels
instead.
- 22 -
