u
Press
F3
so you are controlling the left-right parameter, this will be
shown on the Genesys software.
u
Rotate a Ch V-Pot and the pan position will change for that track.
u
Press a Ch V-Pot and it will toggle the
Input Monitoring
on/off for
that
track.
u
Press
F5
and
FLIP
should now be on. With FLIP on the Genesys faders
will now have the functionality of the Ch V-Pots (the DAW faders will now
be controlled by the Ch V-Pots).
u
With
FLIP
on, pressing a tracks Ch V-Pot will still toggle the
Input
Monitoring
on/off for
that track.
PLI
u
Press the
PLI
button and it will light up. PLI is used to control
Inserts
(Plug-ins)
.
u
Make sure the
F5
button is not on i.e.
FLIP
is off. If FLIP is on press
F5
to turn it off.
The Genesys software (at the top) will indicate the function or mode you
are in
Plug-ins / Inserts Channel View Mode
. DAW control allows you
to control up to 8 plug-ins per track.
u
Press the
fader
SEL
button for DAW track 1 (or the first assigned DAW
track). You have now selected DAW track 1. You will see in the top right
corner the display indicator has changed to
01
(if not already) to indicate
you have selected track 1. The fader SEL button will also flash.
u
F1
,
F2
or the
fader SEL
buttons are used to select which DAW track
you are controlling. When a plug-in is active and shown on the DAW use
the fader SEL buttons to select the DAW tracks.
u
F3
and
F4
buttons are used to select the plug-ins parameter pages.
The number of parameter pages depends on the number of controls on a
plug-in and the size of the (DAW assigned) console surface. The Genesys
software will display on the track information text the pages/parameters
under control.
u
The DAW control assigns the plug-ins parameters pages to the console
surface. For smaller consoles the pages will be more in number, for
consoles larger than for example 32 channels, the plug-ins parameters
may be completely laid out across the (DAW assigned) console surface,
therefore there maybe no pages to shift up/down to for certain plug-ins.
u
Press
F3
until the track information on the Genesys software shows you
are on
Page: 01/
xx
, where
xx
is a number representing the maximum
number of parameter pages, i.e.
Page: 01/07
.
u
Page: 01/xx
is used to setup the plug-in.
u
The
first Ch V-Pot
of that page selects which insert slot is currently
being edited by rotating the Ch V-Pot.
u
The
third Ch V-Pot
of that page selects a plug-in by rotating the Ch
V-Pot, once a plug-in is selected pause for a couple of seconds for the
plug-in to be set. If no plug-in is selected for the current insert slot, the
display will show
No Effect
.
u
After a plug-in is selected the
second Ch V-Pot
of that page
sets the
plug-in on/off by rotating the Ch V-Pot.
u
By pressing
F3
and
F4 button
you can go up down the parameter
pages.
u
Change the parameter values by rotating the Ch V-Pots.
- 189 -
