7000 Series L3 Managed Switch Reference Manual for Software v1.0
7-24
Switching Commands
May 30, 2003 Beta Draft
bases. This field displays the forwarding database ID in an IVL
system. This field will not be displayed in an SVL system.
Agetime
displays the address aging timeout for the associated forwarding
database in IVL. In an SVL system, this will display the system's
address aging timeout value in seconds.
config forwardingdb agetime
This command configures the forwarding database address aging timeout. In an IVL system, the
[fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not used and will
be ignored if entered.
Default
The default value for <10-1,000,000> is 300 seconds
Format
config forwardingdb agetime
<10-1,000,000>
[fdbid/all]
Seconds
The <seconds> parameter must be within the range of 10 to
1,000,000 seconds.
Forwarding Database ID
Fdbid (Forwarding database ID) indicates which forwarding
database's aging timeout is being configured. All is used to configure all forwarding database's
agetime. In an SVL system, the [fdbid/all] parameter is not used and will be ignored if entered.
Device Configuration Commands
This section describes device configuration commands.
show switchconfig
This command displays switch configuration information.
Format
show switchconfig
Broadcast Storm Recovery Mode
May be enabled or disabled by selecting the corresponding
line on the pull-down entry field. The factory default is disabled.
802.3x Flow Control Mode
May be enabled or disabled by selecting the corresponding line
on the pull-down entry field. The factory default is disabled.
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...