7000 Series L3 Managed Switch Reference Manual for Software v1.0
7-64
Switching Commands
May 30, 2003 Beta Draft
Format
logout
transfer upload mode
This command specifies whether XMODEM or TFTP mode is used when uploading from the
switch.
Default
xmodem
. This is valid only when the transfer is initiated by the
serial EIA 232 port.
Format
transfer upload mode
<xmodem|tftp>
transfer upload serverip
This command sets the IP address of the server on which the file is located.
Note:
This command is valid only when the transfer mode is TFTP. See “transfer upload mode” .
Default
0.0.0.0
Format
transfer upload serverip
<ipaddr>
transfer upload path
This command sets the directory path used to upload the file. The switch “remembers” the last file
path used.
Note:
This command is valid only when the transfer mode is TFTP. See “transfer upload mode” .
7000 Series L3 Managed Switch Software supports TFTP client. The TFTP client path statement
requirement is sever dependent. A path statement is generally required to setup the TFTP client;
however, the client path may remain blank.
See the example of the path setup.
TFTP Upload Example:
The TFTP upload example details three scenarios for TFTP client to server file
transfer.
In the example, the operator will upload the config.bin file from the switch to the
location c:\tftp\ on the server. The different scenarios are detailed below:
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...