7000 Series L3 Managed Switch Reference Manual for Software v1.0
Switching Commands
7-51
May 30, 2003 Beta Draft
config spanningtree configuration name
This command sets the Configuration Identifier Name for use in identifying the configuration that
this switch is currently using. The <name> is a string of at most 32 characters.
Default
The base MAC address displayed using hexadecimal notation as
specified in IEEE 802 standard.
Format
config spanningtree configuration name
<name>
config spanningtree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using. The <revision> is a number in the range of 0 to
65535.
Default
0
Format
config spanningtree configuration revision
<0-65535>
show spanningtree port
This command displays the settings and parameters for a specific switch port within the common
and internal spanning tree. The <slot.port> is the desired switch port.
Format
show spanningtree port <slot.port>
Port mode
Enabled or disabled.
Port Up Time Since
Counters Last Cleared
Time since port was reset, displayed in days, hours, minutes, and
seconds.
STP BPDUs Transmitted
Spanning Tree Protocol Bridge Protocol Data Units sent
STP BPDUs Received
Spanning Tree Protocol Bridge Protocol Data Units received.
RST BPDUs Transmitted
Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
RST BPDUs Received
Rapid Spanning Tree Protocol Bridge Protocol Data Units
received.
MSTP BPDUs Transmitted
Multiple Spanning Tree Protocol Bridge Protocol Data Units sent
MSTP BPDUs Received
Multiple Spanning Tree Protocol Bridge Protocol Data Units
received.
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...