NETGEAR ProSafe GSM7324, Reference Manual, Page: 153 / 263

7000 Series L3 Managed Switch Reference Manual for Software v1.0
Routing Commands 8-25
May 30, 2003 Beta Draft
config router ospf virtif delete
This command deletes the OSPF virtual interface from the given interface, identified by <areaid>
and <neighbor>. The <neighbor> parameter is the IP address of the neighbor.
Format
config router ospf virtif delete <areaid> <neighbor>
config router ospf virtif authtypekey
This command configures the authentication type and key for the OSPF virtual interface identified
by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the neighbor. The
value for <type> is either none or simple. The [key] is composed of standard displayable, non-
control keystrokes from a Standard 101/102-key keyboard. The authentication key must be 8 bytes
or less if the authentication type is simple password. If the key is cryptographic, the key may be up
to 256 bytes. Unauthenticated interfaces do not need an authentication key.
Default
The default value for authentication type is none. The default
password key is not configured.
Format
config router ospf virtif authtypekey <areaid> <neigh-
bor> <none|simple> [key]
config router ospf virtif transdelay
This command configures the transit delay for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the
neighbor. The range for <seconds> is 0 to 3600 (1 hour).
Default
1
Format config router ospf virtif interval transdelay <areaid>
<neighbor> <0-3600>
config router ospf virtif interval dead
This command configures the dead interval for the OSPF virtual interface on the virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the IP address of the
neighbor. The range for <seconds> is 1 to 65535.
Default
40
Format
config router ospf virtif interval dead <areaid>
<neighbor> <1-65535>