7000 Series L3 Managed Switch Reference Manual for Software v1.0
7-52
Switching Commands
May 30, 2003 Beta Draft
config spanningtree port bpdumigrationcheck
This command forces the specified port to transmit RST or MST BPDUs. The port <slot.port> is
the desired switch port. To set the migration check for all ports with a single command, "all" can
be specified. Note that the forceversion parameter for the switch must be set to 802.1w or 802.1s.
Default
disable
Format
config spanningtree port bpdumigrationcheck
<slot.port/all> <enable/disable>
config spanningtree port mode
This command sets the Administrative Switch Port State to a new value for the specified port. The
port <slot.port> is the desired switch port. To enable or disable all ports with a single command,
"all" can be specified. Note that only 4095 ports can be enabled.
Default
disable
Format
config spanningtree port mode <slot.port/
all> <enable/disable>
show spanningtree bridge
This command displays spanning tree settings for the bridge.
Format
show spanningtree bridge
Bridge Priority
Configured value.
Bridge Identifier
Bridge Max Age
TConfigured value.
Bridge Hello Time
Configured value.
Bridge Forward Delay
Configured value.
Bridge Hold Time
Minimum time between transmission of Configuration Bridge
Protocol Data Units (BPDUs)
config spanningtree bridge maxage
This command sets the Bridge Max Age parameter to a new value for the common and internal
spanning tree. The maxage <value> is in whole seconds within a range of 6 to 40, with the value
being less than or equal to "2 times (Bridge Forward Delay - 1)".
Default
20
Summary of Contents for ProSafe GSM7324
Page 4: ...May 30 2003 Beta Draft iv...