Mitsubishi 3000GT 1991, Service Manual

Page: 370 / 1146

CLUTCH
Clutch Control
03FOOE
Air intake hose B
Air
hose C
Air intake hose A
Air hose C
Air hose A
14. REMOVAL OF CLUTCH HOSE
To disconnect clutch hose from the clutch tube, proceed as
follows:
Secure the nut on the clutch hose and loosen the flare
nut on the clutch tube.
(2) Remove the clip from the clutch hose to remove clutch
hose from bracket.
OF CLUTCH TUBE A (CLUTCH
HOSE SIDE) 16. CLUTCH TUBE B (CLUTCH
HOSE SIDE)
While holding the clutch hose side nut, loosen the clutch
tube flare nut.
INSPECTION
JCAF
l
Check the clutch hose or tube for cracks or clogging.
SERVICE POINTS OF INSTALLATION
16. INSTALLATION OF CLUTCH TUBE B 15.
CLUTCH TUBE A 14. CLUTCH HOSE 12.
CLUTCH TUBE
Be careful that the clutch hose does not become twisted.
13. INSTALLATION OF CLUTCH RELEASE CYLINDER
On AWD-vehicles, use a flat type short box wrench to
tighten the clutch release cylinder mounting bolts.
8. INSTALLATION OF VACUUM PIPE
If the vacuum pipe has a stepped part, connect the vacuum
hose to the pipe securely, up to the stepped part, as shown
in the illustration.
7. INSTALLATION OF AIR CLEANER COVER, AIR INTAKE
HOSE A
Align slots indicated by arrows in air intake hose A with
markings on air intake hoses B and C; then, insert hoses B
and C all the way into air intake hose A.
Insert air intake hoses B and C all the way up to the roots on
the turbocharger end.
5. INSTALLATION OF AIR HOSE A
Connect the air hoses ensuring that alignment marks are
aligned with projections.
Insert air hoses B and C into pipe all the way to its step.
Caution
Be careful not to allow any foreign matter to get into
the hoses, pipes, or the intercooler itself.
TSB Revision