Mitsubishi 3000GT 1991, Service Manual

Page: 852 / 1146

STEERING
Power Steering Gear Box
seal
Back-up washer
Guide
Needle roller
Vent hole
SERVICE POINTS OF REASSEMBLY
34. INSTALLATION OF BACK-UP WASHER 33. OIL SEAL
(1) Apply a coating of the specified fluid to the outside of
the oil seal.
Specified fluid: MITSUBISHI PLUS
transmission fluid “DEXRON” or
“DEXRON II”
Using a tool, press the back-up washer and the oil seal
into the rack housing to the specified position (where
the upper surface of the press-in guide coincides with
the stepped part of the press-in tool).
32. INSTALLATION OF NEEDLE ROLLER BEARING
(1) Apply specified fluid to housing, bearing and oil seal
press fitting surface.
Specified fluid: MITSUBISHI PLUS
transmission fluid “DEXRON” or
“DEXRON II”
(2) Press fit needle roller bearing.
Caution
Press fit straight as valve housing is aluminium.
31. INSTALLATION OF BALL BEARING
Press fit ball bearing.
28. INSTALLATION OF OIL SEAL 27. O-RING
Apply a coating of the specified fluid to the outside of
the oil seal and O-ring.
Specified fluid: MITSUBISHI PLUS
transmission fluid “DEXRON” or
“DEXRON II”
Press fit oil seal until it touches rack bush end.
26. INSTALLATION OF RACK
(1) Apply a coating of multipurpose grease to the rack teeth
face.
Caution
Do not close the vent hole in the rack with grease.
TSB Revision