Mitsubishi 3000GT 1991, Service Manual

Page: 972 / 1146

51-34
EXTERIOR
Windshield Wiper and Washer
Connector B
mark: A
Inspection of Wiper Relay (Built-in Column Switch)
(1) Check to ensure that there is continuity between terminals
and and between the terminals and and that
there is no continuity between terminals and
Connect the positive terminal of the battery to terminal
and the negative terminal to terminal to check that the
battery voltage is available at terminal
INSPECTION OF WASHER MOTOR
When the washer motor is inspected, make sure that it is
mounted on the washer tank and that the washer tank is
filled with water.
Connect the battery as shown to check whether water is
pumped out.
INSPECTION OF WASHER FLUID LEVEL
Connect a circuit tester to the connector of the level sensor
as shown.
Check that when the float is moved down, the circuit is
closed and that when the float is moved up, the circuit is
opened.
Front deck garnish
SERVICE OF INSTALLATION
2. INSTALLATION OF WIPER ARM
The wiper arms, right and left, are different in shape.
Check the identification symbol.
(2) After the wiper blades have been set, install them in
such a way that the ends of the wiper blades will stop at
the specified positions (standard values).
Standard value: (A) 15 mm in.)
TSB Revision