Mitsubishi 3000GT 1991, Service Manual

Page: 718 / 1146

REAR SUSPENSION Trailing Arm
Bolt B
Guide shaft
, center
M B 9 9 1 2 5 4
(3) Set the special tool onto the trailing arm as shown in the
illustration.
lubricant to the sliding portion of the special tool
(at the arrow marked “A” in the illustration).
(2) Install bolt B to the trailing arm, at the point shown in
the figure.
(4) Use a spanner, etc., to turn the portion marked “C” in the
illustration to remove the connecting rod.
(5) installation of the body (special tool) should be performed
with the screw shaft and guide shaft center lines oriented
as shown in the illustration.
(6) soapy water to the rubber portion of the connecting
(7) Reverse the removal procedures to press-fit.
(8) Remove the special tool after aligning the holes in the
special tool and trailing arm.
(9) Tighten the bolts and nuts to the specified torque.
Tightening torque 98 Nm (71
the trailing arm bushing. (Refer to
TSB Revision