Mitsubishi 3000GT 1991, Service Manual

Page: 771 / 1146

SERVICE BRAKES
Service Adiustment Procedures
141029
1. Visually check the brake pad thickness through the inspec-
tion hole in the caliper body.
Standard value: mm in.)
Limit: 2.0 mm in.)
Caution
Replace the pad if worn beyond the limit. At this time,
replace the pads on right and left wheels as a set.
2. Remove the guide pin, raise the caliper assembly, and
support it with a wire, etc.
Caution
The guide pin has been coated with special
Do
not wipe off the special grease on the lock pin, and do
not contaminate the lock pin.
3. Remove the following parts from the caliper support.
Pad and wear indicator assembly
assembly
I
Outer shim
4. Measure the rotating torque of the hub with the pads
removed to determine brake drag torque after pads are
installed.
5. Install the pad clips to the caliper support in position.
TSB Revision