Mitsubishi 3000GT 1991, Service Manual

Page: 405 / 1146

MANUAL TRANSAXLE
Transaxle Assembly
22-25
Slit
Spring pin
Shift rail
I I
201034
er
2150008
(2) When installing, make sure that the slit of the spring pin
is aligned with the shift rail center line.
46. INSTALLATION OF REVERSE IDLER GEAR SHAFT
Install in the direction illustrated.
35.37. 40. 42. INSTALLATION OF SPACERS
(1) Place two pieces of solder measuring about mm
in.) in length and 1.6 mm in.) in diameter as
illustrated and install the outer races.
Install the transaxle case and tighten the bolts to
specified torque.
Remove the transaxle case.
(4) Remove the outer races and remove the solder.
If solder is not crushed, perform steps (1) to with a
solder with a larger diameter.
(6) Measure the thickness of the crushed solder with a
micrometer and select and install a spacer of thickness
that gives standard preload and end play.
Standard value:
Input shaft end play
0 0.05 mm (0 in.)
Intermediate gear preload
0.05 0.10 mm in.)
Output shaft preload
0.05 0.10 mm in.)
Differential case preload
0.05 0.10 mm in.)
33. INSTALLATION OF OIL SEAL
Install the drive shaft oil seal using the special tool.
vision