Mitsubishi 3000GT 1991, Service Manual

Page: 906 / 1146

42-34
BODY Quarter Window Glass
SERVICE POINT OF REMOVAL
1. REMOVAL OF QUARTER WINDOW AND
GLASS
For protection of the body (coated surface), apply cloth
3
tape to all around the body where the glass is installed.
(2) Using a cutter knife, cut off the quarter window
moulding along its edge.
(3) Run a wire between the glass and the body at the upper
portion of the quarter window and pull it back and forth
along the glass to cut through the adhesive.
When doing so, pay attention to the bolt.
Caution
Hold the window glass with the glass holders to
prevent it from falling when the adhesive is cut
through.
(4) Using a sharp knife, scoop out existing adhesive from
the body flange to 2 mm in.) or less thickness all
around the window opening.
(5) Finish smooth the flange surface.
Caution
1. Do not remove the adhesive more than
sary.
2. Use care not to damage the coated surface of
the body with the knife. If it is damaged, apply
retouch paint or anti-corrosive.
(6) Degrease using 3M ATD Part No. 8906 or equivalent.
C a u t i o n
After degreasing, allow three minutes or more to
dry well before next work. Do not touch the
degreased surface.
T S B R e v i s i o n