Mitsubishi 3000GT 1991, Service Manual

Page: 530 / 1146

23-78
AUTOMATIC TRANSAXLE
Transaxle Assembly
bearing retainer
TFA0149
Place mm-long in.), 1.6 mm-dia. in.) solders at
the locations shown of the output bearing retainer and
install the outer race.
Install the output bearing retainer and tighten bolts to
specification.
Loosen the bolts and remove the output bearing retainer.
(7) Remove the outer race from the output bearing retainer and
remove the solders. If the solders are not crushed, use
larger dia. (3 mm or
in.) solders to repeat steps to (6).
Measure the thickness of the solders crushed with a
micrometer and select a spacer to obtain the specified
preload.
Standard value:
0.075
0 . 1 3 5 m m
(8) Install the spacer selected in the preceding step as well as
outer race into the output bearing retainer.
(9) Fit a new O-ring over the periphery of the output bearing
retainer.
(lO)Coat the O-ring with ATF and tighten the output bearing
retainer mounting bolts to specification.
the output flange into the case and fit the snap ring
over the periphery of the bearing.
TSB Revision