Mitsubishi 3000GT 1991, Service Manual

Page: 508 / 1146

23-56
AUTOMATIC TRANSAXLE
Transaxle Control
INSPECTION
l
Check the control cable for function and for damage.
l
Check the outer cable (key interlock cable, shift lock cable)
for damage and spring for breakage and tension.
l
Check the inner cable (key interlock cable, shift lock cable)
for extension.
REVERSE POSITION ALARM BUZZER
Check that the buzzer sounds when battery voltage is applied
across terminals.
SERVICE POINTS OF INSTALLATION
19. CONNECTION OF SHIFT LOCK CABLE (BRAKE PEDAL
SIDE)
Connect the shift lock cable so that its threads measure
about 4 mm
in.).
Caution
Do not change the routing of shift lock cable to the
selector lever assembly.
16. INSTALLATION OF SLIDE LEVER 15. KEY INTERLOCK
CABLE (STEERING LOCK ASSEMBLY SIDE) 14. CAM
LEVER
(1) Place the ignition key at the “LOCK” position or keep it
removed.
(2) Install the slide lever, key interlock cable, and cam lever
to the steering lock assembly as shown.
Caution
Do not change the routing of key interlock cable to
the selector lever assembly.
5. CONNECTION OF TRANSAXLE CONTROL CABLE
(SELECTOR LEVER ASSEMBLY SIDE)
Connect the transaxle control cable, then make the follow-
ing adjustment.
Place the selector lever in “N” position.
Loosen the nut and slightly pull the transaxle control
cable in the direction of the arrow; then, tighten the nut.
4. CONNECTION OF SHIFT LOCK CABLE (SELECTOR LEV-
ER ASSEMBLY SIDE)
(1) Place the selector lever in “P” position.
(2) Disconnect the key interlock cable from the selector
lever assembly side.
(3) Turn the lock cam B counterclockwise (arrow to
move the set lever upward (arrow
(4) the cutout in set lever to the jock ot lock cam
TSB Revision