Mitsubishi 3000GT 1991, Service Manual

Page: 499 / 1146

AUTOMATIC TRANSAXLE
Service Adjustment Procedures
SERVO ADJUSTMENT
(1) Remove dust, dirt, and other contaminants completely from
(K/D) servo cover and surrounding areas.
(2) Snap off the snap ring and remove K/D servo switch.
(3) Fit claw of special tool into cutout in piston to prevent
piston from turning and use adapter to fix the piston into
position.
Caution
1. Do not push piston with the special tool.
2. Secure adapter only hand-tight to L/R brake press-
ure take-up port and do not apply
torque.
(4) Loosen lock nut to immediately before V-groove in adjust
rod (see illustration on left) and tighten special tool (Inner
Wrench) until it contacts lock nut.
(5) Fit special tool (Outer Wrench) over the lock nut. Turn Outer
Wrench counterclockwise and turn inner cylinder clockwise
to lock the lock nut and special tool (Inner Wrench).
(6) Fit torque wrench to special tool (Inner Wrench) and repeat
tightening and loosening cycle two times with a torque of
Nm (7.2 Then, torque to 5 Nm (3.6
Next, back off special tool (Inner Wrench) 2 to turns.
(7) Fit special tool (Outer Wrench) to lock nut.
Turn Outer Wrench clockwise and Inner Wrench counter-
clockwise to unlock the lock nut from special tool (Inner
Wrench).
Caution
Be sure to apply even torque to the two special tools
when unlocking.
TSB Revision