Mitsubishi 3000GT 1991, Service Manual

Page: 516 / 1146

23-64
AUTOMATIC, TRANSAXLE
Transaxle Assembly
Remove the nut and move the bolt so that a spanner
can be applied to the transaxle mount bracket mounting
bolt; then, remove the transaxle mount bracket mount-
ing bolt.
15. DISCONNECTION OF TIE ROD END 16. LOWER ARM
BALL JOINT
Refer to GROUP 22 Manual Transaxle.
19. REMOVAL OF DRIVE SHAFT (LEFT SIDE) AND INNER
SHAFT ASSEMBLY 20. DRIVE SHAFT (RIGHT SIDE)
Refer to GROUP 22 Manual Transaxle.
24. REMOVAL OF SPECIAL BOLTS 25. TRANSAXLE
ASSEMBLY LOWER PART COUPLING BOLT 26.
TRANSAXLE ASSEMBLY
Support the transaxle assembly with the transaxle jack.
the crankshaft, remove the special bolts at four
(3) After removing the special bolts, push the torque
converter toward transaxle so that it does not remain on
the engine side.
Remove coupling bolt at the bottom of transaxle
assembly and lower the transaxle assembly.
SERVICE POINTS OF
26. INSTALLATION OF TRANSAXLE ASSEMBLY
Attach the torque converter on the transaxle side and
mount the transaxle assembly on the engine.
Caution
If the torque converter is mounted first on the engine,
the oil seal on the transaxle side may be damaged.
Therefore, be sure to first assemble the torque conver-
ter on the transaxle side.
20. INSTALLATION OF DRIVE SHAFT (RIGHT SIDE)
Refer to GROUP 22 Manual Transaxle.
5. CONNECTION OF TRANSAXLE CONTROL CABLE
(1)
Connect the transaxle control cable to the manual
control lever and tighten the nut temporarily.
(2) Loosen the nut, pull the transaxle control cable lightly in
the arrow direction and retighten the nut.
TSB Revision