Mitsubishi 3000GT 1991, Service Manual

Page: 615 / 1146

REAR AXLE
Drive Shaft
INSPECTION
l
Check the drive shaft boots for damage or deterioration.
l
Check the ball joints for excessive play or check operation.
l
Check the drive shaft spline for wear or damage.
MB991380
Two-part serration
SERVICE POINTS OF INSTALLATION
4. INSTALLATION OF OIL SEAL
If the oil seal is to be replaced because of damage, drive
it in by using the special tool.
(2) Apply the specified grease to the oil seal lip.
2. INSTALLATION OF DRIVE SHAFT
Caution
I. Be cautious to ensure that the differential carrier oil
seal is not damaged by the drive shaft spline.
2. The right drive shaft for models equipped with the
LSD having a VCU has a two-part serration. Be very
careful to install each one on the correct side.
NOTE
The left and right drive shafts can also be distinguished
from each other by the identification color of boot band
(B.J. side).
Drive
shaft
LH
RH
Boot band (B.J. side)
identification color
White
Blue
I
Caution
Be sure to thoroughly remove any oil or grease, etc.
from the threaded part of the bolt and nut used for
installation to the companion flange, because any oil,
grease, etc. on these parts might cause later loosening
even though tightening is at the specified torque.
TSB Revision
1