Mitsubishi 3000GT 1991, Service Manual

Page: 1065 / 1146

SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
2. Repair Procedure
(1) If air bag deployed in the collision, remove the deployed
air bag module. (Refer to
(2) Check the SRS components using the table shown
below.
If the SRS components are showing any visible damage
such as dents, cracks, or deformation, replace them
with new ones.
Refer to appropriate INDIVIDUAL COMPONENT SER-
VICE,
(3) Conduct self-diagnosis using Multi-use Tester to ensure
entire SRS operates properly except open circuit of air
bag module (22.
TRBL 2).
(4) Install new air bag module. (Refer to
Components Inspection
(when air bag deploys in collision)
Inspection (when air bag does not deploy
in low-speed collision)
Front impact sensors Replace front impact sensors.
(Refer to
(1) Check front upper frame lower and sensor
brackets for deformities or rust.
(2) Check sensor cases for dents, cracks deformi-
ties or rust.
(3) Check sensor harnesses for binds, connectors
for damage, and terminals for deformities.
diagnosis unit
SDU)
Replace SRS diagnosis unit.
(Refer to
(1) Check SDU case and brackets for dents, cracks
or deformities.
(2) Check connectors and lock lever for damage,
and terminals for deformities.
bag module Replace air bag module.
(Refer to
(1) Check pad cover for dents, cracks or
ties.
(2) Remove air bag module from steering wheel.
Check hooks and connector for damage, termi-
nals for deformities, and harness for binds.
(Refer to
(3) Check air bag inflator case for dents, cracks or
deformities.
(4) Install air bag module to steering wheel
fit or alignment with the wheel.
Steering wheel/steering
(1)
column/intermediate
Replace steering wheel, steering
column and intermediate joint.
Remove air bag module from steering wheel.
(Refer to
(Refer to GROUP Steering (2)
Wheel and Shaft.)
Check wiring harness (built into steering wheel)
and connectors for damage, and terminals for
deformities.
(3) Install air bag module to check fit or alignment
with steering wheel.
(4) Check steering wheel for noise, binds or
difficult operation and excessive free play,
Clock spring Replace clock spring. (1) Check clock spring connectors and protective
tube for damage, and terminals for deformities.
(2)
the case and the gears for
Harness connector
and Front wiring
connectors for poor connections.
(2)Check harnesses for binding, connectors for damage, and terminals for deformities.
(Refer to and
TSB Revision