Mitsubishi 3000GT 1991, Service Manual

Page: 293 / 1146

CRUISE CONTROL SYSTEM Cruise
Control Svstem
Vacuum hose
SERVICE POINT OF REMOVAL
20. REMOVAL OF AIR BAG MODULE
Remove the negative terminal of the battery and wait
for more than 30 seconds.
Caution
The capacitor in the SRS diagnosis unit retains
enough voltage to deploy the air bag for a given
period even after disconnection of the
battery.
If an
operation is performed during that given period,
unintended deployment of the air bag could result
and cause serious injury.
(2) Remove the air bag module. To remove the clock spring
connector (squib connector) from the air bag module,
force the lock outward and pry it with a plain screwdriv-
er as shown at left so that no undue force will be
exerted on the connector when it is removed.
(3) The removed air bag module should be stored in a
clean, dry, flat place with the pad side up.
INSPECTION
l
Check the inner and outer cable for damage.
l
Check the cable for smooth movement.
l
Check the link protector for damage.
INSPECTION OF INDIVIDUAL PARTS
Refer to Service Adjustment Procedures Individual Parts
inspection
SERVICE POINT OF INSTALLATION
6. CONNECTION OF VACUUM HOSE TO VACUUM PUMP
Route the vacuum hose over the throttle cable and connect
the hose to the vacuum pump so as to prevent the
slackened hose from interfering with other parts.
TSB Revision