Mitsubishi 3000GT 1991, Service Manual

Page: 46 / 1146

GENERAL
Maintenance Service
9. Install the radiator cap securely.
10. engine and warm up until the thermostat opens.
11. Race the engine up to around 3,000 rpm several times, then
stop the engine.
,
12. When the has cooled down, remove the radiator cap
and add coolant up to the brim. Add coolant to the reserve
tank up to the FULL line.
<Turbo>
1. Lift up the vehicle.
2. Loosen the radiator drain plug, remove the drain plug from
the rear bank of the engine and remove the radiator cap to
discharge coolant.
3. Follow the same steps 3 to 12 above.
12. DISC BRAKE PADS (Inspect for wear)
MOOSBFD
Check for fluid contamination and wear. Replace complete set
of pads if defective.
Caution
The pads for the right and left wheels should be replaced at
the same time. Never “split” or intermix brake pad sets. All
four pads must be replaced as a complete set.
Thickness of lining (A):
Limit 2.0 mm in.)
13. BRAKE HOSES (Check for deterioration or
leaks)
MOOSBHB
Inspection of brake hoses and tubing should be included in all
brake service operations.
The hoses should be checked for:
Correct length, severe surface cracking, pulling, scuffing or
worn spots. (If the fabric casing of the hoses is exposed by
cracks or abrasion in the rubber hose cover, the hoses
should be replaced. Eventual deterioration of the hose may
occur with possible bursting failure.)
2. Faulty installation, casing twisting or interference with
wheel, tire or chassis.
14. BALL JOINT AND STEERING LINKAGE SEALS
(Inspect for grease leaks and damage)
1. These components, which are permanently lubricated at
the factory, do not require periodic lubrication. Damaged
seals and boots should be replaced to prevent leakage or
contamination of the grease.
2.
Inspect the dust cover and boots for proper sealing, leakage
and damage. Replace them if defective.
TSB Revision