Mitsubishi 3000GT 1991, Service Manual

Page: 380 / 1146

CLUTCH
Clutch Cover and Disc
grease
Clutch disc
Clutch cover
assembly
TSB Revision
SERVICE POINTS OF INSTALLATION
5. APPLICATION OF GREASE TO RELEASE FORK
(1) Apply a coating of the specified grease to the point of
contact with the fulcrum and the point of contact
the release bearing.
Specified grease: MITSUBISHI genuine grease
Part No. 0101011 or equivalent
Caution
When installing the clutch, apply grease to each
part, but be careful not to apply excessive grease;
excessive grease will cause clutch slippage and
shudder.
(2) Apply a coating of the specified grease to the end of the
release cylinder’s push rod and to the push rod hole in
the release fork.
Specified grease: MITSUBISHI genuine grease
Part No. 0101011 or equivalent
4. APPLICATION OF GREASE TO CLUTCH RELEASE BEAR-
ING (FWD)
Pack the inner surface of the clutch release bearing and the
groove with the specified grease.
Specified grease: MITSUBISHI genuine grease
Part No. 0101011 or equivalent
2. APPLICATION OF GREASE TO CLUTCH DISC 1.
CLUTCH COVER ASSEMBLY
Apply a coating of the specified grease to the clutch
disc spline, and then use a brush to rub it in.
Specified grease: MITSUBISHI genuine grease
Part No. 0101011 or equivalent
(2) Using the universal clutch disc aligner, position the
clutch disc to the flywheel.
(3) Install the clutch cover assembly. Tighten the bolts a
little at a time, working in a diagonal sequence, finally
tightening them to the specified torque.