Mitsubishi 3000GT 1991, Service Manual

Page: 574 / 1146

PROPELLER
Shaft
inner race
Recessed end
of inner race
Chamfered end
of cage
Rubber
(2) Put the cage on the inner race with the mating marks
aligned and install two balls, one in a groove and the
other in the groove opposite to that groove.
Both balls should be placed in the grooves where they
were before disassembly.
(3) Assemble the inner race and cage in the outer race with
their mating marks aligned.
NOTE
Make sure that the recessed end (where snap ring will
be fitted) of inner race, the recessed end (where
packing will be fitted) of the outer race, and the
chamfered end of the cage are all on the same side.
Also ensure that the relative positions of the inner and
outer races are as shown in the illustration.
(4) Install the remaining balls in their original positions.
(5) Check that the outer race rotates on the inner race
smoothly.
(6) Apply specified grease to the Lobro joint assembly.
Specified grease: Repair kit grease
55 g (1.59 1.94
(7) Apply quick fix adhesive at three locations illustrated to
prevent displacement of the rubber packing and fix it to
the Lobro joint assembly temporarily.
Specified adhesive: 3M ATD Part No. 8155 or
equivalent
(8) Lining up the mating marks on the Lobro joint assembly
and the center propeller shaft and applying the socket
to the inner race of the Lobro joint assembly, install the
Lobro joint assembly to the center propeller shaft.
TSB Revision