MIMAKI cg-100AP, Instruction Manual

Page: 154 / 180

5-8
Abnormal Plotting Out Operation
Plotter is inoperative
• The interface cable is not connected. If there is no [*] (under data receiving) display at right
upper part in the LCD, refer to Chapter 1 "CONNECTION OF CABLES" (P.1-19), and confirm
the connection.
• The offline mode is selected.
Refer to Chapter 1 "OPERATION MODES" (P.1-26), and select the online mode.
Frequent Occurrence of Error
• Erroneous communication conditions
Refer to Chapter 1 "SETTING OF COMMUNICATION CONDITIONS" (P.1-29), and properly
set the conditions.
Miss Sizing of Pattern Paper
• Error in resolution setting
Refer to Chapter 3 "RESOLUTION SETTING" (P.3-24), and set the proper value.
Extrusion of Pattern Paper from the Paper
• Error in positioning of origin
Refer to Chapter 3 "CHANGE OVER OF ORIGIN" (P.3-10), select the proper position of origin.
• Error in scaling
Refer to Chapter 3 "PLOTTING SCALE SETTING" (P.3-14), and change the scale value.
Autocut disables the Paper to cut
• Low cutting pressure
Refer to "AUTOCUT SETTING" (P.2-18), and set the proper value of press force.
• Increase the auto-cut pressure in increments of 10 g to establish a proper
value.
Autocut does not cut the Paper
• Data received from host computer exclude the necessary EOF command, or the EOF command
at the plotter side is turned OFF (close time is not set).
Refer to Chapter 1 "EOF Command and Close Time Setting" (P.1-34), and properly set the autocut.
Modify to output the necessary EOF command from the host computer.
• The plotter shakes the paper so as to completely cut the roll paper after
cutting with the cutter. The more frequency of the shakes the easier
cutting.
Increase frequency of the [SHAKING SET] in Chapter 3 "SYSTEM SET-
TING" (P.3-27).