CHAPTER 4
SELF DIAGNOSIS FUNCTION
4-7
DEMONSTRATION PATTERN (#1, #2)
Plot a demonstration pattern so as to verify the operation and evaluate the performnce. There are two patterns as
follows.
The plot out shall be accomplished by setting leaf paper or roll paper of which size is A2 or over.
Demo-pattern #1 ................ This is a pattern to verify the plotting quality and function. The plot corre-
sponds to the set paper in size. When you execute this pattern, set pens or
mechanical pencils in the magazine Nos. 1 to 8.
If the cutter is installed, it will be ignored.
The sample of the patterns areshown in P.4-9.
Demo-pattern #2 ................ This is a pattern to evaluate the performance. When you execute this pat-
tern, set pens or mechanical pencils in the magazine Nos. 1 to 4. The sample
of the patterns are shown in P.4-10.
1
Set the pen in the magazine, then
install onto the main unit.
Refer to Chapter 2 "Preparation of
the Tools" (P.2-21).
2
Set the paper.
Refer to Chapter 2 "PAPER SET-
TING" (P.2-25).
3
Select the offline mode.
Execute Chapter 3 "DATA CLEAR"
(P.3-4).
4
Display the fifth page of the menu.
5
Select [SELF TEST], and the follow-
ing display will be appeared.
-PAGE+
<--SELFTEST PRM-LIST-->
<--LINE : OFF DUMP-->
-F1+
PLOT # 1 PLOT # 2
SMPL-CUT SQR-CUT
Summary of Contents for cg-100AP
