MIMAKI cg-100AP, Instruction Manual

Page: 97 / 180

CHAPTER 2
BASIC OPERATION
2-27
PAPER SETTING
7 . Select [ROLL].
Depress the applicable key.
• The initial value of paper
drawing length for the paper
detection operation is 3 m.
• To change the paper drawing
length, refer to the “AUTO
FEED SETTING.” (See page 3-
15.)
-F3+
(ROLL)
The display show left is appeared.
The plotter starts detecting the
m e d i a .
8 . When the movement stops, the
display as shown left will be ap-
peared. The
***part will be changed
from 5 to 1.
• Depressing during
displaying this picture
causes to move into the
offline mode.
9 . All movements stop and the mode
becomes under the online mode.
• When the paper is set, the UNIT automatically becomes under the online
mode. If you want to change the tools conditions, communication condi-
tion and etc. after setting the paper, select the offline mode or pause
mode.
• If you want to move the origin, refer to Chapter 3 "MOVEMENT OF ORIGIN"
(P.3-12).
• When the online mode is selected, in some cases, the plotter may start
moving. In such case, follow the instruction of this chapter "Pause of Plot
Out" (P.2-33). Thereafter, start over to set paper again.
• To prevent the paper from moving out of position before receiving data,
the machine performs longitudinal feeding approximately once a minute
after paper loading.
P A P E R L O A D I N G
( R O L L )
READY)
X sec!
ONLINE)