MIMAKI cg-100AP, Instruction Manual

Page: 116 / 180

3-8
PERFORMANCE OF COPYING
• The copying is unachievable under the pause mode.
•When no data exist in the receiving buffer (such that no data have been
received after turning the system ON), the copying is unachievable.
• The copying of data beyond the capacity of the receiving buffer in size is
unachievable.
Plot out the residual data in the receiving buffer once again. As far as data exist in the receiving buffer, the
copying can be repeated. The plot out of the copy differs depending on the EOF command in the "Block: 4".
Refer to Chapter 1 "Change of Communication Conditions" (P.1-30). For the explanation, examples for receiv-
ing of Data 1, Data 2 and Data 3 in order shall be given.
EOF command ON
Data 3 that is firstly received will be
the object to be copied. Data 2 and 3
can not be copied. Send the data
once again for the copy. Along with
EOF command for each page or send
data one by one page for copying
without EOF command.
EOF command OFF
Since there is no pause in the receiv-
ing buffer, all data in the receiving
buffer will be copied on the same
paper. When the command of the
"CUT" in the submenu of the copy is
turned ON, the paper cut off by every
copying.
1 Plot out the data. Refer to Chapter 2
for the operation. The operation
after plotting out will be differed in
accordance with type of the set
p a p e r .
• In the case of roll paper; After plot out, the offline mode proceeds with Step 4 and the
online mode proceeds with Step 3.
• In the case of leaf paper; Remove the paper and proceed with Step 2.
Data 3
Data 2
Data 1
In the receiving buffer
Data 3
Data 2
Data 1
In the receiving buffer