MIMAKI cg-100AP, Instruction Manual

Page: 114 / 180

3-6
Type of Tool Command Setting Value
PENCIL 0.5 Force 15, 20 - 450g (10g step)
Speed 2, 5 - 85cm/s (5cm/s step), 120cm/s
Acceleration 0.3, 1 - 4G (1G step), 5.7G
PENCIL 0.4 Force 15, 20 - 400g (10g step)
Speed 2, 5 - 85cm/s (5cm/s step), 120cm/s
Acceleration 0.3, 1 - 4G (1G step), 5.7G
PENCIL 0.3 Force 15, 20 - 350g (10g step)
Speed 2, 5 - 85cm/s (5cm/s step), 120cm/s
Acceleration 0.3, 1 - 4G (1G step), 5.7G
PENCIL 0.2 Force 15, 20 - 200g (10g step)
Speed 2, 5 - 85cm/s (5cm/s step), 120cm/s
Acceleration 0.3, 1 - 4G (1G step), 5.7G
ANOTHER Force 15, 20 - 450g (10g step)
Speed 2, 5 - 85cm/s (5cm/s step), 120cm/s
Acceleration 0.3, 1 - 4G (1G step), 5.7G
The maximum speed is 60 cm/s when a roll paper is used.
CHANGE OF THE TOOLS CONDITIONS
Establish operating conditions for plotter pens of REGISTER Nos. #1, #2 and #3 according to the type of paper
and tool to be used.
The contents and values of the setting are as follows.
Refer to Chapter 1 [MERITS OF THE TOOLS] (P.1-36) for the tools conditions compatible with the tools and/or
paper.
This setting is stored even if the power is turned OFF.
1 Under the offline mode, the first page
of the menu will be displayed.
2 Select [PEN SET], and the following
display will be appeared.
3 Select [SAVE No]. The No. will be
changed whenever the key is de-
pressed. Display the applicable No.
4 Select [PARAM], and the following
display will be appeared.
-PAGE+
<--CLEAR AUTO CUT-->
<--PEN SET HALF CUT-->
-F3+
<--SAVE No. : # 1 ASSIGN-->
<--MODE : AUTO PARAM-->
-F1+
<--SAVE No. : # 2 ASSIGN-->
<--MODE : AUTO PARAM-->
CUTTER PARAMETER
PEN PARAMETER
-F4+