MIMAKI cg-100AP, Instruction Manual

Page: 39 / 180

CHAPTER 1
SET-UP
1-23
POWER ON/OFF
• Make sure the following items before turning the power ON.
The media set lever shall be the up position.
The movable portion of the plotter and nearby shall be cleared from the
media, pen and etc.
Turning the power ON
1 Turn the power ON. The power
indicating lamp will be turned ON.
2 The display as shown left will be
a p p e a r e d .
• When the optional receiving
buffer is incorporated, the
display as shown left will be
appeared.
3 The carriage moves to the right end.
4 When a magazine is loaded on the
plotter, the message shown in the
illustration given at the left will ap-
pear on the display panel.
If you have replaced the cutter with a
new one before turning the power ON,
press the
-F3+
key.
In any case other than the above, press
the
-F4+
key.
If no magazine is loaded on the
plotter, proceed to Step 6.
5 Initialize the magazine.
System Version * - **
448KB
System Version * - **
448KB + 1MB
C H A N G E C U T T E R B L A D E ?
Y E S N O
M A G A Z I N E I N I T I A L