MIMAKI cg-100AP, Instruction Manual

Page: 155 / 180

CHAPTER 5
TROUBLE SHOOTING AND POSSIBLE REMEDY
5-9
When paper jamming arises
If paper jamming has occurred, do not move the carriage forcibly. Since
the carriage is mounted with sensors, forcibly moving it can damage them.
When paper jamming has arisen, restore the normal state to the machine following the steps of procedure de-
scribed below.
1) Turn OFF the power switch.
2) Raise the sheet set lever.
3) If the carriage can be moved by hand, move it to the right or left from the paper-jammed portion.
If the carriage cannot be moved with ease, first remove the paper jammed from the machine.
4) Remove the paper jammed from the machine.
If a piece of paper has entered the hole in grid roller or in synchro-roller, also remove it.
5) Turn ON the power switch. Check to be sure that the machine normally conducts initialization.
6) Re-load the paper.
For a roll paper, the top end of the paper may have bent or crooked. Correct the paper following the steps of
procedure described below.
a) Draw the paper until a straight part appears on the synchro-roller.
b) Select “AUTO-CUT” with the sheet set lever raised.
c) Then, follow the messages that appear on the operation panel.
The top end of paper is cut straight and the first page under the offline mode appears on the opera-
tion panel.
Hole in synchro-roller
Hole in grid roller