Maeda MK0003, Service Manual, Page: 306 / 348

5-12
2.4 DETAIL OF INVERTER SET ITEMS
The initial setting is as shown in the table below.
Setting
number
Function name Set value
A001
Selection of first frequency
reference
01: Control circuit terminal board
A002
Selection of first operation
reference
01: Control circuit terminal board
A003 First base frequency 50.0
A011 FV start frequency 30.00
A012 FV end frequency 60.00
A013 FV start ratio 45
A014 FV end ratio 60
A015 Selection of FV start 00: Start frequency A011
A016 Analog input filter 30
A019 Selection of multistep speed 01: Bit
A021 Multistep speed reference 1 10.00
A022 Multistep speed reference 2 30.00
A041 Selection of first torque boost 00: Manual torque boost
A061 Upper limit of first frequency 60.00
A062 Lower limit of first frequency 10.00
A081 Selection of first AVR 01: Normally OFF
A082
Selection of first motor
receiving voltage
400: Default value (setting not necessary)
b001
Selection of restart during
momentary power interruption
and under voltage
02: Frequency matching restart
b002
Allowed time for momentary
power interruption and under
voltage
25.0
b003 Waiting time for restart 0.3
b013
Selection of first electronic
thermal properties
00: Reduced torque characteristics
b083 Carrier frequency 2.0
b089
Automatic carrier frequency
reduction
02: Valid, dependent on fin temperature
C003 Multi-function input selection 3 32: SF1
C004 Multi-function input selection 4 33: SF2
C005 Multi-function input selection 5 255: NO
C006 Multi-function input selection 6 12: EXT
C007 Multi-function input selection 7 16: FV/F1
C036
Multi-function relay contact
selection
00: NO (a contact)
Set the software lock by manual operation
after
writing the setting.
Setting number Set value
b031 02: Change disabled except b031