3.8.3
Connecting Hydraulics
WARNING
Do NOT use remote hydraulic system pressures over 3000 psi (20,684 kPa). Check your tractor operator’s
manual for remote system pressure.
NOTE:
Refer to colored bands on hoses to identify lift, steering/transport, and tilt hose sets.
Table 3.4 Hydraulic System Hoses
System
Hose
Tractor
Hydraulics
Lift
A
(1 hose standard
2 hoses with
ETO installed)
Control 1
Steering and
Transport
B
(2 hoses)
Control 2
Mower
Conditioner Tilt
C
(2 hoses)
Control 3
Figure 3.34: Hydraulic Connections
1. Connect one
LIFT
cylinder hose (A) (two hoses
required if endwise transport system installed) to
activate the following tractor hydraulic controls:
Table 3.5 Lift System
Control Lever
Position
Cylinder
Movement
Mower
Conditioner
Movement
Forward
Retract
Lower
Backward
Extend
Raise
2. Connect two
STEERING
cylinder hoses (B) to activate
the following tractor hydraulic controls:
Table 3.6 Steering and Transport System
Control Lever
Position
Cylinder
Movement
Mower
Conditioner
Direction
Forward
Extend
Right
Backward
Retract
Left
169820
49
Revision A